EXFO FTB-8500 Series for FTB-500 User Manual
Page 103
Advertising
Creating and Starting a Test Case
Ethernet and Fibre Channel Application
89
Ethernet RFC 2544 Test Case
2. Port configuration:
2a. Select the port Connector
Type (Optical or
Electrical RJ-45). Optical is automatically selected for the
Ethernet 10G interface.
2b. For FTB-8510B, select the
port number by pressing
on Port 1 or Port 2.
2c. For Electrical RJ-45, if
required, select the Ethernet port
crossover check box to inverse the
pin-to-pair assignment of the UTP cable used.
Note: At this point you should have a link up indicated in the Tree view tab. A
green LED indicates a link up while a red LED indicates a link down. For
electrical port, if the link is down, make sure that the Ethernet port
crossover setting is correct.
2d. Press Next.
Advertising
This manual is related to the following products: