EXFO FTB-8500 Series for FTB-500 - Manual (Page 83)

Creating and Starting a Test Case
Ethernet and Fibre Channel Application 69
Introducing the Test Setup
Steps Available with
The Test step is the root of the test case. It allows the configuration
of the test name, test application type, Interface Type, topology, and
Clock Mode. For RFC 2544, the selection of the sub tests and dual
test set are also available.
All tests
The Port step allows the selection and configuration of the physical
port and for 10Gig-E interface the configuration of the transceiver
mode (LAN or WAN). For WAN transceiver mode, the WIS step will
be inserted in front of the Framing step.
All tests
The WIS step indicates that the WAN transceiver mode is selected.
Available with 10Gig-E interface only.
WAN transceiver
mode only
The Framing step allows the selection of the test framing layer. All tests
The Network step allows the selection of the network
Ethernet/Fibre Channel parameters for the port.
All test at the
exception of BERT
Unframed,
Framed Layer1
and Fibre Channel
The Traffic Stream step allows traffic stream configuration. All Ethernet tests
except
Smart Loopback
The Remote Module step allows the selection of a remote
compatible module (FTB-8510B, FTB-8510G, FTB-8525/FTB-8535,
FTB-8120NGE/FTB-8130NGE, and RTU-310/RTU-310G).
EtherSAM and
RFC 2544 Dual
Test Sets tests
only
The Pattern step allows the selection of the pattern. BERT test only