EXFO FTB-8500 Series for FTB-500 User Manual
Page 96
![background image](/manuals/736442/96/background.png)
Creating and Starting a Test Case
82
FTB-8500 Series and FTB-8120NGE/8130NGE
Ethernet EtherSAM (Y.1564) and RFC 2544 Dual Test Set Test Cases
4. Framing configuration.
4a. Set the Auto-Negotiation,
Speed, Duplex, and Flow
Control parameters. Not
available with Ethernet
10G. Refer to Interface
Setup (Ethernet) on
page 140 for more
information.
4b. Set the VLAN parameters
when required. Refer to
MAC on page 218 for more information.
4c. Select the Frame Format. Choices are Ethernet II and 802.3
SNAP. Refer to Network on page 148 for more information.
4d. Set the IP Version (IPv4 or IPv6). IP Version is only available
when the IPv6 software option (SK-IPV6) is enabled.
4e. For IPv4, select the Automatic IP Address check box to
dynamically obtain an IP address from a DHCP (Dynamic Host
Configuration Protocol) server or set the source and destination IP
addresses, Subnet Mask, and the Default Gateway. Refer to IPv4
Configuration on page 483 for more information.
4f. For IPv6, press the IPv6 Config button to set the IPv6 settings.
Refer to IPv6 Address Configuration on page 485 for more
information.
4g. Press Finish to complete the test setup on this remote module.
The RFC 2544’s Global tab is automatically displayed.
When the test is created as remote on a unit or on a compatible unit
(FTB-8510B, FTB-8510G, FTB-8525/FTB-8535,
FTB-8120NGE/FTB-8130NGE, or RTU-310/RTU-310G), the SUI is limited
to the following: Test Setup, Tools, System, and About tabs; favorites,
save, load, and report functionality. No test configuration and results
are available.