Altera LVDS SERDES Transmitter / Receiver User Manual

Page 37

Advertising
background image

Parameter

Type

Description

inclock_data_alignment

String

Specifies the phase alignment of the

rx_in

and

rx_inclock

input ports in terms of the

rx_

inclock

frequency. The clock phase alignment

for the

inclock_data_alignment

parameter

specifies the positive phase shift needed for the

clock for alignment with the data.
This parameter is only used by the RTL

simulation model and has no affect on how the

Fitter sets the PLL parameters.
The following are the parameter values and the

corresponding phase shifts in degrees (°):

EDGE_ALIGNED: 0°

45_DEGREES: 45°

90_DEGREES: 90°

135_DEGREES: 135°

CENTER_ALIGNED: 180°

225_DEGREES: 225°

270_DEGREES: 270°

315_DEGREES: 315°

If omitted, the default value is

EDGE_ALIGNED

.

inclock_period

Integer

Specifies the period or frequency of the

rx_

inclock

port. The default time unit is an

integer in picoseconds (ps). In AHDL designs

only, strings, such as 50.5 MHz, are acceptable.

inclock_phase_shift

Integer

This parameter is used to set the phase shift

parameters used by the PLL. Specifies a phase

shift in 15° increments.

input_data_rate

Integer

Specifies the data rate into the PLL. The

multiplication value for the PLL is

INPUT_DATA_

RATE/INCLOCK_PERIOD

.

lose_lock_on_one_change

String

Specifies when the DPA circuitry should lose

lock. You must enable the

rx_dpa_locked

port

and the

enable_dpa_mode

parameter if this

parameter is specified. Values are

ON

and

OFF

. If

omitted, the default value is

ON

.

number_of_channels

Integer

Specifies the number of LVDS channels.

outclock_resource

String

Specifies the clock resource type to use with the

rx_outclock

port. The values are

AUTO

,

Regional Clock

, and

Global Clock

. If

omitted, the default value is

AUTO

.

pll_operation_mode

String

Specifies the source synchronous mode for

Cyclone II and Stratix II device LE PLLs. The

values are

NORMAL

and

SOURCE_SYNCHRONOUS

. If

omitted, the default value is

NORMAL

.

UG-MF9504

2014.12.15

Command Line Interface Parameters

37

LVDS SERDES Transmitter/Receiver IP Cores User Guide

Altera Corporation

Send Feedback

Advertising