BINDER UF V 500 - Manual (Page 30)

UF V (E2+E2.1) 03/2013 page 30/112
3. Completeness of delivery, transportation, storage, and installa-
tion
3.1 Unpacking, and checking equipment and completeness of delivery
After unpacking, please check the unit and its optional accessories, if any, based on the delivery receipt
for completeness and for transportation damage. Inform the carrier immediately if transportation damage
has occurred.
Caution: The drain well is placed under the unit between the castors. Please remove it before unpacking
the freezer!
CAUTION
Sliding or tilting of the unit.
Damage to the unit.
∅
Do NOT lift the unit using the door, the housing of the automatic door mechanism or
the lower housing.
∅ Do NOT lift the unit by hand.
∅ Do NOT transport the unit horizontally.
 Keep the unit in upright position. Max. angle of inclination during transport: 10°.
 Lift the unit using technical devices (fork lifter) from the pallet. Set the fork lifter laterally
or from the rear in the middle of the unit. Make sure to place all the lateral supports of
the unit on the forks (check: the fork protrudes at the opposite unit side).
 Wear suitable shoes (safety shoes).
The final tests of the manufacturer may cause traces of the shelves on the inner surfaces. This has no
impact on the function and performance of the unit.
Please remove any transportation protection devices and adhesives in/on the unit and on the doors and
remove the operating manuals and accessory equipment.
Remove any protective lamination sheet on the inner metal surfaces prior to commissioning.
Wait at least 8 hours following transport with technical devices (chap. 3.2.2) before start-up.
If you need to return the unit, please use the original packing and observe the guidelines for safe lifting
and transportation (chap. 3.2).
For disposal of the transport packing, see chap. 15.1.
Scope of delivery
•
Ultra-low temperature freezer UF V
• 2 keys for the main power switch (key switch)
• 3 shelves,12 shelf holders and 3 fixing plates with screws
• DIN plug for the zero-voltage relay alarm output
• Starter set RFID cards (master card, switch-off card, 3 user cards) (standard with UF V, option for
UF V UL)
• Data logger (standard with UF V UL, option for UF V)
• 2 spacers for rear wall distance.
• Operating manual