CONTA-CLIP CONTA-Sign 5.2 - Manual (Page 16)

Page 16 of 67
You can change the following settings:
Font style, font size, bold, underline, left align, center, right align, rotate labeling by
90° at a time, number of lines, line spacing.
Changed settings can be saved as standard user settings by clicking on the Floppy
disc icon in the upper right tool bar.
Click on the Arrow icon at the end of the toolbar to restore all factory default settings.
Note:
The typeface selection in Bold or Italic is only available using the thermo transfer or
office printer.
If you have selected a plotter or an engraver as your device, you can modify specific
settings with reference to the relevant output device. The settings are displayed in the
lower part of the window.
The right section of the window provides you with special symbols and special
characters for the selected font type. Those could vary from type to type.
The extended character set provides country-specific characters and special symbols
for selection. This means that labels for other countries can be created without any
problem.
Country specific character sets such as Baltic, Greek, Turkish, Cyrillic etc. are
provided within the typeface ISO_3098_international or Block_Light_international
to be selected within the drop down menu.
In addition serif and ornamental typefaces can be chosen to be used spec. for
engraving.
Various Symbols and dedicated symbol fonts are available for selection, you can find
easily when checking the box Show symbol fonts only.
With the selection of the symbol font IEC 60414 you can find 11 sub folders within the
drop down menu to select symbols from. The font Symbol 1 and Symbol 2 are
showing additional technical symbols.
A detailed list of the available symbols you can find under > Help from the main menu.
You can select the check box within the font selection in order to show
> Symbol fonts only.