CONTA-CLIP CONTA-Sign 5.2 - Manual (Page 66)

Page 66 of 67
14.4 Standard font type
You can specify a standard font for the different output devices.
By using the menu > Options > Standard font, you can select the font type that you
would like to use as standard for a particular output device.
If you have selected a marking element for labeling, the standard font type is
preset.
If you change the font type, then in
future the font type that you last
selected will be retained when you
use that marking element.
14.5 Standard pen sizes
Up to four different pen sizes (line thicknesses) can be used in the pen depot on the
Plotter full size (DIN A3) and Plotter half size (DIN A4).
The following configuration is preset: Position 1: .18 mm, Position 2: .25 mm,
Position 3: .35 mm and Position 4: .50 mm.
You can change these settings using the menu item
> Options > select standard pen sizes.
Click on the pen sizes to determine which pen sizes should be used as standard.