CONTA-CLIP CONTA-Sign 5.2 - Manual (Page 25)

Page 25 of 67
- Pen size for graphic elements
You have the option of creating layouts on tags. These functions are detailed in the
section entitled > Create layouts on tags <. This enables you for example to create
text fields with frames, borders, etc. You can specify a particular pen for these graphic
elements.
- Plot speed for graphic elements
This enables you to select a particular plot speed for drawing graphic elements.
- Selected text will be printed
If you select this option, only the text you have previously selected will be printed.
- All selected tags will be printed
If you select this option, only the tags you have previously selected will be printed.
- All selected segments will be printed
With this option, only previously selected segments will be printed. You make your
selection by clicking on one or more segments on screen. You can select more than
one segment by holding down the Control key whilst clicking on the various
segments you wish to select.
Note:
If you are using the Plotter Basic half size (DIN A4) as the output device, some
options are not available for selection since this plotter has no pen depot and no
priming disk.
Support plates tab
This shows which labeling elements are being used and checks whether the
relevant support plate has been fitted
for the plotter. If a support plate is
missing or if the support plate is not
compatible with the labeling element,
the corresponding segment is
highlighted in red.
Note:
The Plotter Basic half size (DIN A4) has no support plate recognition and therefore
no check can be made to ensure the correct support plates have been fitted.