CONTA-CLIP CONTA-Sign 5.2 - Manual (Page 4)

1. System requirements
PC with 1.8 GHz (min.), 512 MB RAM, graphic resolution 1024 x 768,
40 GB hard drive, USB interface / Windows 2000, XP, Vista and Windows 7/8
2. Software installation
First close all other applications.
Insert the software installation CD into your CD-ROM drive.
Installation will begin automatically. You should follow the on-screen instructions. If the
auto-start feature has been switched off on your PC, double-click to start the program
XXXX_setupx.x.xxxx_xxxxxx.exe.
When installation is complete, you can start the program by double-clicking on the
program icon. Install the driver for the output device from the CD acc. to your
operating system and follow the instructions.
Language selection is automatic according to the country-specific version of Windows.
For country-specific versions of Windows where the program provides no individual
language version, the English version is automatically installed. You can override the
settings under > Options > Language setting.
3. Output devices supported by the program
The labeling and engraving software version 5.2 supports the following output
devices:
- Plotter
Labeling devices for labeling all current labeling elements that are used in switch
cabinets and plant construction.
- Plotter full size (DIN A3)
- Plotter Basic half size (DIN A4)
- Engraving Unit (option)
Engraving device for engraving plastic, aluminum and brass plates.
Connecting the engraving unit to one of the plotter versions provides you with access
to the following engraving devices:
- Engraver full size (DIN A3)
- Engraver Basic half size (DIN A4)
- Engraving Unit (dedicated)
- Engraver full size (DIN A3)
- Engraver half size (DIN A3)
Note:
The plotter versions and the engraving units can be run with this program solely via a
USB connection.
Page 4 of 67