CONTA-CLIP CONTA-Sign 5.2 - Manual (Page 58)

Page 58 of 67
When you have finished dividing the strip into partitions, you first click on the Apply
button. This completes the horizontal division.
After that, you can make a vertical division for each partition. Click on Crosswise for
the relevant strip.
Then the following window opens up:
To enter the required subdivision of the strip,
proceed as follows:
First enter the tag width and then the number of
tags.
By clicking on the Add button, the data is
transferred to the field below. If the strip is not yet
fully divided up, you will be shown the length of strip
that is still available. Now you can specify other tag
widths.
When you click on Apply, the program takes you
back to the previous window and displays the
subdivision that you have specified.
In this way you can subdivide the individual
partitions using different tag widths in succession
as required. When you have finished all the
subdivisions, close the Designer.
You can select the labeling element you have
created in the folder < User defined under >
Manufacturer and call it up for printing.
Note:
If you have created the labeling data for a strip and are printing out the print data on a
thermo transfer printer, there is the opportunity to define various options for printing.
You can determine whether dividing marks as separating lines or dots should also be
printed.