Rena T-750 - Manual (Page 13)

ASSEMBLY AND INSTALLATION
SECTION 2 - Assembly and Installation
Choosing a Location
Place the T-750 with its feeder on a sturdy worktable or cabinet at least 12 inches from any
walls. Allow enough room to place the Feeder on the same work surface. Protect the T-750
from excessive heat, dust, and moisture – avoid placing it in direct sunlight.
CAUTION
THE UNIT IS HEAVY.
IT IS STRONGLY RECOMMENDED THAT TWO TECHNICIANS REMOVE THE
TABBER FROM THE CARTON AND PLACE IT ON THE WORKING SURFACE.
Installing the Reel Assembly
1. Place the Reel assembly over the Guide
Pin [1]. Make sure that the head is over
Guide Pin [2] while you are tightening
the Tab Positioning Knob [3] clockwise.
NOTE: Make sure the plastic bushings
[4], located at the front and back of the
hole for Guide Pin [1], are installed.
4
5
2. When the Reel assembly is completely
seated, plug in the reel assembly power
cord [5], as shown.
13