Rena T-750 - Manual (Page 15)

ASSEMBLY AND INSTALLATION
Plugging in the Feeder and Tabber
Make sure that the emergency stop switch of the T-750 is in the OFF position and the main
power switch above the power cord receptacle is in the OFF position. Make sure that the power
switch on the feeder is in the OFF position also.
1. Connect one end of the Tabber
power cord [1] to the rear of the
T-750 in the corresponding
receptacle.
2. Connect one end of the Feeder
power cord [2] to the rear of the
Feeder in the corresponding
receptacle.
3. Plug the other end each cord into
a 115-220 Volt AC, 50/60 Hz.
Grounded outlet.
CAUTION
Do not use adapter plugs or extension
cords to connect the tabber or the feeder
to the wall receptacle.
Do not use outlets controlled by wall
switches.
Do not use an outlet that shares the
same circuit with large electrical
machines or appliances.
T-750 and Optional EasyFeed Lite Feeder shown.
4. Connect the appropriate Feeder Interface Cable [3] (see list below) to the Feeder and to
the lower connector on the Tabber.
Part #
Description
35E-500-191 Cable A (EasyFeed 120 Feeder <---> T-750). Cable included with T-750.
35E-500-196 Cable D (EasyFeed 120 Feeder <---> T-750 <---> Envelope Imager XT3.0/XT4.0)
33E-500-197 Cable F (EasyFeed Lite Feeder <---> T-750 <---> Envelope Imager XT3.0/XT4.0)
35E-500-190 Cable G (EasyFeed Lite Feeder <---> T-750). Cable included with EasyFeed Lite.
35E-500-195
1, 2 Cable H (EasyFeed 120 Feeder <---> T-750 <---> Envelope Imager III or PS2000)
35E-500-198 2 Cable I (AF500 Feeder <---> T-750 <---> Envelope Imager III or PS2000)
1
Requires cable part # 32-40215-001 when connecting the Envelope Imager III.
Requires cable part # 620.5.906, when connecting to PS2000 based systems.
2
Can also be used to connect AF500 to T-750 without an in-line printer (printer connection not used).
CAUTION! Be sure you are using the appropriate cable with the appropriate feeder/tabber/printer or
damage may result.
15