Rena T-750 - Manual (Page 18)

SETUP AND OPERATION
T-750 Tabber Operations Rev. 3/4/08 18
TAB REEL
TAB REEL
SIDE GUIDE
TAB DRIVE
PRESS ROLLER
TAB DRIVE
ROLLER
Feeder Setup, EasyFeed Lite (optional)
The feeder is properly aligned with the Tabber when it is installed. The Operator Side Guide in
the feeder is fixed in position for proper alignment of the media.
Adjusting the feeder to feed media is performed as
follows:
1. Open the non-operator side guide to provide
room for the media.
2. Loosen the separator locking knobs and raise
the sheet separators. Install one sheet of media
under the separators and lower them into
contact with the media. Tighten the locking
knobs.
NOTE: For media thicker that ½ folded sheets
you can add one sheet of the material to the media
before tightening the locking knobs. This gives
thicker media a little more room to feed.