ATL Telecom IP-3072 PoE Smart Office IP Telephone - Manual (Page 76)

Page 76
MOCET IP3072 Smart Office IP Desk Phone Administrators' Guide
Appendix A – Emergency Firmware
Upgrade
This firmware upgrade method is only applicable for distributor who has been authorized in
the local repair right.
Preparing Materials
Before starting upgrade, please make sure you have the following materials ready.
Software List
 TFTP software (file name: tftpd32.328)
 Console cable driver (file name: Console cable driver-CP210x_Drivers)
 Telnet client software (teraterm_utf8-4.58.exe)
 F/W for Main Board - BCM1104 (appsip.bin.gz)
 F/W for Codec Board - MP421 (file name: SD)
Hardware List
 IP3072 phone and its adapter----- 1 unit
 PC or Notebook with one USB port and Ethernet port ------1 unit
 Console cable for IP3072 -----1 unit
 MicroSD card ----- 1 unit
 MicroSD card reader ----- 1unit
 Switch hub and its adapter----- 1 unit
 Ethernet cable ----- 2 pcs
 Pin header jumper ----- 1 unit
Software Environment Setup
Installing the Console Cable Driver
1. Open the file of “Console cable driver-CP210x_Drivers”.
2. Open the file of “PreInstaller.exe”, and then the screen below will show up.
3. Press “Install” to start installation. (You may encounter some warning messages
during installation. Please skip it. Finally, the installation completion message will
show up.)
Installing the Telnet Client Software
1. Open the file of “teraterm_utf8-4.58.exe”, and then the screen below will show up.
2. Press “Next” to continue the installation until installation completed.