H3C Technologies H3C SR6600-X - Manual (Page 19)

9
IMPORTANT:
To mount multiple devices in the rack, place the heaviest one at the bottom of the rack.
Unpacking the router
Unpack the router as shown in Figure 4 .
Figure 4 Unpacking the router
Installing the router in a 19-inch rack
Before you install the router to a rack, wear an ESD-preventive wrist strap. For how to wear an
ESD-preventive wrist strap, see “ ESD prevention .” The SR6602-X1 and SR6602-X2 are installed in the
same way. The SR6602-X1 is used as an example in this section.
To install the router in a rack:
1. Mark the positions of cage nuts on the front rack posts by using a front mounting bracket and mark
the positions of cage nuts on the rear rack posts by using a rear mounting bracket. See
Figure 5 .
Figure 5 Marking the positions of the cage nuts
2. Insert one edge of a cage nut into the hole, and use a flat-blade screwdriver to compress the other
edge of the cage nut to push the cage nut fully into the hole.
Packing belt
Foam brace