H3C Technologies H3C SR6600-X - Manual (Page 36)

26
T1 cable
You can use an 8T1 interface cable to connect to MIM-8T1/MIM-8T1-F modules.
Figure 29 8T1 splitter cable
CAUTION:
•
When connecting the interface cable, pay attention to the mark on the interface to avoid wrong
insertion, which may damage the interface module or even the router.
• H3C recommends that you install a lightning protector at the input end of the 8T1 cables to protect them
against lightning strikes more efficiently when they are led outdoors.
Connecting an E1/T1 cable
Connecting an E1 cable (D15/D68 <----> BNC)
CAUTION:
When connecting the interface cable, pay attention to the mark on the interface to avoid wrong insertion,
which may damage the interface module or even the router.
• If you do not need to extend the cable, you can directly connect the BNC connectors of the E1
75-ohm cable to the remote network device as follows.
a. Connect the D15/D68 connector of the E1 75-ohm cable to the D15/D68 interface of the
interface module and fasten the bolts to fix the cable.
b. The other end of the cable provides one pair or multiple pairs of 75-ohm BNC connectors.
Connect the TX connectors and the RX connectors on this end to the RX connectors and the TX
connectors on the remote device respectively.