Replacing a mim – H3C Technologies H3C SR6600-X User Manual
Page 53
Advertising
43
Figure 54 Pulling the HIM out of the slot
3.
If you do not install a new HIM in the slot, install a blank panel. To install a new HIM, see “
.”
Replacing a MIM
NOTE:
To replace a MIM module when the router is running, perform the remove slot
slot-number command and
then unplug the module.
To replace a MIM:
1.
Determine the MIM to be removed. Use a flat-blade screwdriver to completely loosen the captive
screws of the MIM to be removed.
2.
Holding the handle of the MIM, gently pull the MIM out of slot along the slide rails.
Figure 55 Pulling the MIM out of the slot
3.
If you do not install a new MIM in the slot, install a blank panel. To install a new MIM, see
“
.”
Advertising