H3C Technologies H3C SR6600-X - Manual (Page 52)

42
Replacing a FIP module
CAUTION:
When the RUN LED of the FIP module is fast flashing, do not unplug the FIP module.
To replace a FIP module, for example, FIP-20:
1. Determine the FIP module to be removed. This section takes the FIP module in slot 3 as an example.
2. Use a Philips screwdriver to loosen the captive screws of the FIP module to be removed until all
spring pressure is released.
3. Holding the ejector levers of the FIP module with both hands, pull the ejector levers outward, and
gently pull the FIP module out of the slot along the slide rails.
Figure 53 Pulling the FIP module out of the slot
4. If you do not install a new FIP module in the slot, install a blank panel. To install a new FIP module,
see “
Installing a FIP module .”
NOTE:
To replace a FIP module when the router is running, perform the remove slot slot-number command and
then unplug the module.
Replacing a HIM
NOTE:
To replace a HIM module when the router is running, perform the remove slot slot-number command and
then unplug the module.
To replace a HIM:
1. Determine the HIM to be removed. Use a flat-blade screwdriver to loosen the captive screws of the
HIM to be removed until all spring pressure is released.
2. Grasping the two ejector levers with both hands, pivot the ejector levers outward, and gently pull
the HIM out of the slot along the slide rails.