Installing a him – H3C Technologies H3C SR6600-X User Manual
Page 24
14
Figure 11 Installing a FIP module
NOTE:
•
For more information about the FIP LEDs, see “
•
Do not insert or remove a HIM/MIM into or from a FIP module when the RUN LED on the FIP is flashing
fast. Otherwise, an exception may occur.
Installing a HIM
NOTE:
•
Only the FIP-20 supports HIMs.
•
Before you install a HIM, make sure that the ejector levers are in the open position away from the HIM
module panel.
To install a HIM:
1.
Locate the slot to install the HIM on the FIP module.
A HIM occupies two slots of the FIP module.
2.
Loosen the captive screws on a filler panel with a Phillips screwdriver, and then use a flat-blade
screwdriver to prize the filler panel to remove it from the router.
Repeat the same step to remove the other filler panel. Keep the filler panels safe for future use.
3.
Use even pressure to push the HIM slowly along the slide rails into the slot, and then pull the levers
inward.
4.
Use a Phillips screwdriver to fasten the captive screws on the HIM.