H3C Technologies H3C SR6600-X - Manual (Page 91)

81
Item Specification
Transmission
power
Type
Short-haul
multi-mode
(850 nm) Mid-haul
single mode
(1310 nm)
Long haul
(1310 nm) Long haul
(1550 nm)
Super long
haul (1550
nm)
Minimum –9.5 dBm –9 dBm –2 dBm –4 dBm –4 dBm
Maximum 0 dBm –3 dBm 5 dBm 1 dBm 2 dBm
Receive sensitivity –17 dBm –20 dBm –23 dBm –21 dBm –22 dBm
Central wavelength 850 nm 1310 nm 1310 nm 1550 nm 1550 nm
Fiber type
62.5/125 μm
multi-mode 9/125 μm
single mode 9/125 μm
single mode 9/125 μm
single mode 9/125 μm
single mode
Max. transmission distance
0.55 km
(0.34 miles) 10 km (6.21
miles) 40 km (24.86
miles) 40 km (24.86
miles) 70 km (43.50
miles)
Operating mode 100/1000 Mbps, full duplex
10 Gbps Ethernet port
The SR6602-X2 provides two 10 Gbps Ethernet ports. 10 Gbps SFP+ ports do not support 1000 Mbps
transceiver modules.
Table 35 10 Gbps Ethernet port specifications
Item Specification
Protocol 802.3ae
Connector type LC
Transceiver module type SFP+
Physical layer 10GBASE-R/W
Transmission rate
• LAN PHY—10.3125 Gbps
• WAN PHY—9.95328 Gbps
Table 36 10 Gbps SFP+ transceiver module specifications
Model
Central
wavelength
Connector
type
Fiber type
Max. transmission
distance
SFP-XG-SX-MM850-A 850 nm LC 50/125μm multi-mode 300 m (984.25 ft)
SFP-XG-LX-SM1310 1310 nm LC 9/125μm single mode 10 km (6.21 miles)
SFP-XG-LH40-SM1550 1550 nm LC 9/125μm single mode 40 km (24.86 miles)
Flexible interface platform modules
The SR6602-X Router Series supports flexible interface platform (FIP) modules FIP-10 and FIP-20. You can
install High-speed Interface Modules (HIMs) and Multifunctional Interface Modules (MIMs) on a FIP to
support different network services as needed. A FIP module is located on the lower part of the front
panel.