Installing a mim – H3C Technologies H3C SR6600-X User Manual
Page 25
Advertising
15
Figure 12 Installing a HIM
Installing a MIM
NOTE:
Install the MIM in the lower slot on the FIP module.
To install a MIM:
1.
Locate the slot to install the MIM on the FIP module.
2.
Loosen the captive screws on a filler panel with a Phillips screwdriver, and then use a flat-blade
screwdriver to prize the filler panel to remove it from the router. Keep the filler panel safe for future
use.
3.
Use even pressure to push the MIM slowly along the slide rails into the slot, and then pull the levers
inward.
4.
Use a flat-blade screwdriver to fasten the captive screws on the MIM.
Figure 13 Installing the MIM
Advertising