Sony Ultra Wide Converter For SEL16F28 and SEL20F28 - Manual (Page 102)

6. Menu Display and Settings 102
Network Menu
This section describes the function and settings of each menu item.
Factory default settings are shown in bold (for example,
18dB ).
Network >Access Authentication
Sets settings related to authentication.
Item Sub-item setting Description
User Name Sets the user name for access
authentication.
Password Sets the password for access
authentication.
Network >Wireless LAN
Sets settings related to wireless LAN connections.
Item Sub-item setting Description
Setting Access Point Mode / Station Mode / Off Selects the operation mode of the
wireless LAN connection.
WPS Execute / Cancel Establishes a connection using WPS
(Wi-Fi Protected Setup).
Execute: Execute function.
NFC Execute / Cancel Establishes a connection using NFC (Near
Field Communication).
Execute: Execute function.
MAC Address Displays the MAC address of the wireless
LAN interface of the camcorder.
Network >AP Mode Settings
Sets settings related to access point mode connections.
Item Sub-item setting Description
Channel Auto(5GHz) / Auto / CH1 / CH2 / CH3 /
CH4 / CH5 / CH6 / CH7 / CH8 / CH9 /
CH10 / CH11
Sets the wireless LAN channel.
Auto(5GHz) is available on the PXW-FX9V
only.
Camera SSID
& Password Displays the SSID and password of the
camcorder.
Regenerate
Password Execute / Cancel Creates a new password.
Execute: Execute function.
IP Address Displays the IP address of the camcorder
in access point mode.
Subnet Mask Displays the subnet mask of the
camcorder in access point mode.
Network >ST Mode Settings
Sets settings related to station mode connections.
Item Sub-item setting Description
Camera
Remote
Control Enable / Disable Sets whether to enable remote control
from a device connected to the
camcorder by wireless LAN in station
mode.
Connected
Network Displays the connected wireless LAN
network (access point).
SSID Displays the SSID for the access point to
connect.
Security Displays the type of security for the
access point to connect.
Password Displays the password for the access
point to connect.
When Security is set to WEP or WPA:
*******
When Security is set to None: (blank)
DHCP Displays whether DHCP is on/off.
IP Address Displays the IP address of the camcorder
when DHCP is set to Off.
Subnet Mask Displays the subnet mask of the
camcorder when DHCP is set to Off.
Gateway Displays the default gateway of the
camcorder when DHCP is set to Off.
DNS Auto Displays whether DNS acquisition is on/
off.
Primary DNS Server Displays the primary DNS server of the
camcorder when DNS Auto is set to Off.
Secondary DNS Server Displays the secondary DNS server of the
camcorder when DNS Auto is set to Off.