Canon DP-V2421 4K Reference Display - Manual (Page 130)

130 Error Messages
Error Messages
Message Description and Action
Calibration Failed to initialize the external sensor. See CA-310 and CA-210 instruction manual.
Calibration error. • Check the installation and connection of the
external sensor and retry ( 27).
• Perform matrix calibration of CA-310 and CA-210
( 27).
Calibration is completed.
(Brightness setting is lower than target brightness.) Set the "Luminance" in calibration again ( 59).
Failed to detect the external sensor.
Please check the connection with the sensor. Correctly connect the external sensor to the USB
port of this main unit.
Network Communication error. IP address may be in conflict or there may be a
network communication error. Check the network
environment.
Invalid IP Address. Enter the correct IP address.
Invalid Subnet Mask. Enter the correct subnet mask.
Display is not connected. Check that the Canon display to which you wish to
export this video display's settings and this video
display are correctly connected with a LAN cable.
Various settings,
CDL export The USB memory is full. Use another USB memory or delete the content of
the memory.
Failed to write file. The USB memory may be defective or protected.
Check the USB memory.
LUT, Various settings,
CDL import (LUT Import) "LUT Type" is different.
(CDL Import) "File Type" is different. Select the correct file format.
Failed to read file. The USB memory may be defective or protected.
Check the USB memory.
Failed to import. There is an error in the file to be imported. Check the
file.
No import file. Check and ensure that the file has been saved to the
USB memory or imported to "User 1-3".