Canon DP-V2421 4K Reference Display - Manual (Page 16)

16 Installation/Connection
Procedures to attach/detach stands
The main unit comes with two stands which can be detached. The position where the front stand is attached can be
changed.
CAUTION
• Use a flat, clear surface when attaching/detaching the stands.
• The display can tip over if the stand has not been attached.
• Avoid touching the screen during this step as it may damage it.
■ Detaching
1. Place the display with the screen facing down on a soft cloth or cushioning material that is larger than the
display.
2. Front stand: Remove the mounting screws (two each) from the left and right stands.
Rear stand: Remove the mounting screws (one each) from the left and right stands.
Do not lose the removed screws. Do not use these screws for other purposes.
■ Attaching
1. Place the display with the screen facing down on a soft cloth or cushioning material that is larger than the
display.
2. Align the position of the stand and screw hole on the video display.
Alight the convex part of the stand and concave part of the video display.
3. Front stand: Fix the left and right stands using the mounting screws (two each).
Rear stand: Fix the left and right stands using the mounting screws (one each).
Rear
Screen side
Front stand mounting part (inside)
Front stand
Front stand
mounting screw hole
Mounting
screw
Front stand mounting part (outside)
Concave part
Convex part
Concave
part
Rear stand
Convex part
Note
• It is recommended to mount both front stands in either the outside or inside positions.