Turning on the power, Turning on the power of the main unit – Canon DP-V2421 4K Reference Display User Manual
Page 21
21
Turning on the Power
Turning on the Power
This section describes how to turn on the power of the main unit.
Turning on the Power of the Main Unit
1. Plug the provided AC power cord HT-21 to the AC power supply input terminal at the rear.
The video display goes into standby and the power indicator lights up in amber.
2. Press the power supply button at the front.
The power indicator lights green.
Note
• Warming-up is necessary to stabilize the brightness of the video display. Wait at least 10 minutes after turning on the power
before using.
Installing the AC power cord clamp HC-01 (Included)
Install the AC power cord clamp before connecting the AC power cord to the main unit.
1. Insert the AC power cord clamp connector into the cord clamp mounting
hole (
1
).
2. Connect the AC power cord to the main unit (
2
).
3. Secure the AC power cord in place with the holder (
3
).
4. Press the holder against the main unit (
4
).
Make sure that there is no slack (
A
).
• To remove the AC power cord clamp from the AC power cord: Pull the holder
lever (
5
).
• To adjust the length: Push the holder lock lever down (
6
).
• To remove the AC power cord clamp from the main unit: Press the knobs on the
left and right and pull out the clamp (
7
).
2
1
3
4
A
5
6
7