Canon DP-V2421 4K Reference Display - Manual (Page 34)

34 Operating the Video Display
The following content is assigned to channel buttons on the video display by factory default.
CH CH1 CH2 CH3
Input Configuration 3G/HD-SDI HDMI 3G-SDI RAW
12-3G/HD-SDI HDMI 3G-SDI RAW
Select Input Signal Automatic Automatic Automatic
Image Division Automatic Automatic Automatic
Link Order Automatic Automatic Automatic
Format Automatic Automatic Automatic
Audio Input Automatic Automatic Automatic
Marker/TC/CameraInfo Input Input A Input A Input A
Internal Sync Off Off Off
Channel Name (Blank) (Blank) (Blank)
Picture Mode → Type Normal Normal Normal
Picture Mode
Picture Mode L
Resolution 4K ITU-R BT.709 ITU-R BT.709 CINEMA EOS SYSTEM
Picture Mode R
Resolution 2K ITU-R BT.709
Payload UHD/PQ User 1 (2020 PQ)
UHD/HLG User 2 (2020 HLG)
UHD ITU-R BT.2020
709/PQ —
709/HLG —
709 ITU-R BT.709
VANC —
Unknown —
Camera CINEMA EOS
SYSTEM CINEMA EOS SYSTEM
ARRI User 6
VARICAM User 7
Single Input Dual View Off Off Off
Separator Off Off Off
Note
• Holding the CH button down displays the channel list, allowing the user to select the desired channel. However, in the
following cases, a list of input signals will be displayed and the user can temporarily switch signals: When a 12G-SDI signal
or 6G-SDI signal is input; or when video that can be displayed simultaneously with a 12G-SDI or 6G-SDI signal is input and
"Select Input Signal" is set to "Automatic" (
).