Genicom 3600 - Manual (Page 100)

3600 Printer Maintenance Manual
5-14
3600M.052
Upper
media
guide
Lower
media
guide
Label
gap
sensor
Label gap
sensor
housing
Lift spring
Locking
tabs
6. Use a small straight-slot screwdriver to lift up on each of the two molded
tabs that secure the label gap sensor. Slide the label gap sensor from its
housing and replace it with the new label gap sensor. The label gap sensor
should snap into place.
7. Slide the upper media guide plate back together with the lower media
guide plate.
8. Route the label gap sensor cable through the cutout in the main deck plate
and reattach the media guide assembly to the frame. Be sure that the media
brake arm does not rub on the upper media guide and that the sensor cable
is not contacting any moving parts.
9. Attach the label gap sensor cable to the main PCB.
10. Reload media (and ribbon if used) and lower the printhead.
11. Install the electronics cover, the media cover, and the power cord, and
check the printer for proper operation.