Genicom 3600 - Manual (Page 104)

3600 Printer Maintenance Manual
5-18
Replacing the TTR Takeup Hub, Clutch/Pulley, and Belt
To replace the TTR takeup hub, TTR takeup clutch/pulley, and TTR takeup
drive, you will need some or all of the following parts and tools:
•
TTR takeup hub, Intermec Part No. 061562-005
•
TTR takeup clutch assembly, Intermec Part No. 062927S-001 (white)
•
2.800ID x .210 drive belt (O-ring), Intermec Part No. 501462-003
•
Retaining snap rings, Intermec Part No. 501410
•
ESD grounding strap
•
Snap ring pliers
•
#1 and #2 Phillips screwdriver
To remove the TTR takeup hub, TTR takeup clutch/pulley, and TTR drive belt
1. Switch off the printer power and remove the power cord.
2. Remove the media supply cover, the electronics cover, and the front bezel
cover (refer to “Replacing the Bezel PCB” earlier in this chapter).
3. Raise the printhead. Remove media and ribbon if loaded.
4. Remove the two TTR takeup clutch/pulley retaining snap rings and the
thick washer from the end of the TTR takeup hub shaft. Retain the washer.
Discard the old snap rings.
3600M.055
TTR takeup
hub
TTR clutch/
pulley
Snap ring
Thick
washer
Thin washer
TTR drive
gear/pulley
TTR takeup
drive belt