Genicom 3600 - Manual (Page 90)

3600 Printer Maintenance Manual
5-4
Replacing the Lithium Battery
To replace the lithium battery, you will need the following parts and tools:
•
1.75AH 3.6V AA lithium battery, Intermec Part No. 586229
•
ESD grounding strap
•
#2 Phillips screwdriver
WARNING
Warning
There is danger of explosion if the battery is incorrectly replaced. Replace
it only with the same or equivalent type battery recommended by the
manufacturer. Discard used batteries according to the manufacturer’s
instructions.
Il y a danger d’explosion s’il y a remplacement incorrect de la batterie.
Remplacer uniquement avec une batterie du même type ou d’un type
recommandé par le constructeur. Mettre au rébut les batteries usagées
conformément aux instructions du fabricant.
To replace the lithium battery
Note: The printer will lose data if the battery fails or is removed. Before removing the
battery, upload and save the fonts, formats, pages, graphics, and configuration settings.
1. Switch off the printer power and remove the power cord, the media cover,
and the electronics cover.
2. Remove the old battery and install the new battery, matching the (+) and (-)
ends of the battery with the (+) and (-) signs on the main PCB.
Power
Intermec
3600
Alert
Feed/Pause
Empty/Pause
J9
3600M.042
Main PCB
Lithium
battery
3. Install the covers and power cord. Check the printer for proper operation.