Genicom 3600 - Manual (Page 112)

3600 Printer Maintenance Manual
5-26
6. You can replace the liner takeup hub and/or liner reverse gear 1 now.
7. Install the thick washer removed in Step 5 between the liner takeup hub
and the main deck plate. Position liner reverse gear 1 between the motor
plate and the liner takeup subplate and check for proper engagement with
liner reverse gear 2.
8. Insert the liner takeup hub through the main deck plate, reverse gear 1, and
the subplate. Install the washer removed in Step 4 on the hub shaft
extending through the subplate and secure with two new snap rings.
9. Reattach the front bezel cover. Ensure that the media access door operates
properly (snaps firmly shut) after the front bezel cover is installed.
10. Reload media (and ribbon if used) and lower the printhead.
11. Install the electronics cover, the media cover, and the power cord, and
check the printer for proper operation.
To replace the liner drive roller
1. If not already done, switch off the printer power and remove the power
cord, media cover, electronics cover, and the front bezel cover. Raise the
printhead and remove the media and ribbon if loaded.
2. Remove the five screws that secure the lower outboard plate to the main
deck plate and pull the plate away from the rollers. The tear bar and tear
bar support come loose when the outboard plate is removed. Retain them
for reassembly.
3600M.059
Lower
outboard
plate
Tear bar
Snap
ring
Tear bar
support
E-ring
Washer Liner drive
gear/pulley
Liner drive
roller