Genicom 3600 - Manual (Page 110)

3600 Printer Maintenance Manual
5-24
Replacing the Liner Drive and Takeup Components
To replace any combination of the liner takeup hub, liner reverse gears, liner
drive roller, liner takeup clutch/pulley, liner reverse shaft, liner drive
gear/pulley, and liner drive belt, you will need some or all of the following
parts and tools:
•
Liner takeup hub, Intermec Part No. 061562-005
•
Liner drive roller, Intermec Part No. 061568-002
•
Liner reverse gears 1 and 2, Intermec Part No. 061588-002
•
Liner takeup clutch/pulley, Intermec Part No. 061574S-001 (black)
•
Liner reverse shaft, Intermec Part No. 061589-001
•
2.800ID x .210 drive belt (O-ring), Intermec Part No. 501462-003
•
Liner drive gear/pulley, Intermec Part No. 061569-002 (black)
•
Retaining E-rings, Intermec Part No. 501401
•
Retaining snap rings, Intermec Part No. 501410
•
Roller alignment tool, Intermec Part No. T43150
•
ESD grounding strap
•
#1 and #2 Phillips screwdriver
•
Needlenose pliers
•
Snap ring pliers
To replace the liner takeup hub and liner reverse gear 1
1. Switch off the printer power and remove the power cord.
2. Remove the media cover, the electronics cover, and the front bezel cover
(refer to “Replacing the Bezel PCB” earlier in this chapter).
3. Raise the printhead. Remove media and ribbon if loaded.
4. Remove the retaining snap rings that hold the liner takeup hub and liner
reverse gear 1 in place as shown on the next page. Retain the washer
between the snap rings and the liner takeup subplate. Discard the old snap
rings.
5. Pull the liner takeup hub away from the main deck plate to remove it.
Retain the thick washer between the liner takeup hub and the main deck
plate. Liner reverse gear 1 can now be removed from behind the liner
takeup subplate.
Note: Now is a good time to replace other liner drive and takeup components
according to the following procedures.