Genicom 3600 - Manual (Page 114)

3600 Printer Maintenance Manual
5-28
To replace liner reverse gear 2, the liner takeup clutch/pulley, liner reverse shaft,
liner drive gear/pulley, and liner drive belt
1. If not already done, perform Steps 1 through 5 of the preceding liner roller
replacement procedure.
2. Remove the retaining snap ring that holds the liner reverse shaft, takeup
clutch/pulley, and reverse gear 2 in place. Retain the washer located
between the snap ring and subplate. Discard the old snap ring.
Motor
plate
Subplate
Liner
reverse
gear
Liner
reverse
gear
Liner
drive
roller
Liner
drive
roller
3600M.060
Thin
washer
Thin
washer
Snap ring
Snap ring Liner takeup
clutch/pulley
assembly
Liner
reverse
shaft
Liner drive
gear/pulley
Liner
reverse
gear
Lower
drive
belt