Cleaning the printer covers – Genicom 3600 User Manual
Page 44
3600 Printer Maintenance Manual
2-12
5. Pull down on the lower media guide to expose the label gap sensor. Using
a soft bristle brush, remove all debris and dust from the label gap sensor.
6. Clean the label gap sensor with a cotton swab and alcohol.
7. Remove the electronics cover.
8. Very carefully clean the small ribbon motion optical sensor on the main
PCB and the black and white encoder decal on the TTR supply
clutch/encoder assembly with a cotton swab moistened with alcohol.
9. Install the electronics cover.
10. Reload the media (and ribbon if used).
11. Engage the printhead by rotating the head lift lever counterclockwise until
it locks in place.
12. If you are finished cleaning, install the media cover.
Cleaning the Printer Covers
Clean the 3600 printer covers with a general purpose cleaner (soapy
water/mild detergent). Do not use abrasive cleansers or solvents. Be sure to
clean the transparent panel on the media cover so that you can see the media
supply inside the printer when the cover is closed.