Genicom 3600 - Manual (Page 91)

Remove and Replace Procedures
5-5
5
Replacing the Printhead
To replace the printhead, you will need the following parts and tools:
•
6.6-inch 5 mil printhead, Intermec Part No. 061611S-001
•
ESD grounding strap
•
Medium straight-slot screwdriver
To replace the printhead
1. Switch off the printer power and remove the power cord.
2. Remove the media cover.
3. Raise the printhead. Remove media and ribbon if loaded.
4. Release the locks on the printhead cable by pressing in on each side of the
cable connector. Remove the printhead cable.
Note: If you need slack to separate the printhead and cable, unplug the cable from
the main PCB and pull some of it through the cutout in the main deck plate.
Power
Intermec Intermec
3600
Alert
Feed/Pause
Empty/Pause
Power
Intermec Intermec
3600
Alert
Feed/Pause
Empty/Pause
3600M.043
Straight slot
screwdriver
Printhead
cable
Cable
connector
Printhead
Printhead
retaining
screw