Genicom 3600 - Manual (Page 92)

3600 Printer Maintenance Manual
5-6
5. Use a straight-slot screwdriver to loosen the printhead retaining screws,
located in the center of the printhead heatsink. The screw is easier to loosen
if you place one of your fingers underneath the printhead, between the
printhead and the platen roller. Pull the printhead away from the printer
(since it is a tight fit, you may need to pull it out from the outboard side
rather than from the front).
6. Replace the printhead and cable and tighten the printhead retaining screws.
7. Reload media (and ribbon if used) and lower the printhead.
8. Install the media cover and the power cord and check the printer for proper
operation.
Replacing the Bezel PCB
To replace the bezel PCB, you will need the following parts and tools:
•
Bezel PCB assembly, Intermec Part No. 059052S-001
•
ESD grounding strap
•
#1 and #2 Phillips screwdrivers
To replace the bezel PCB assembly
1. Switch off the printer power and remove the power cord.
2. Remove the media cover and the electronics cover.
3. Unplug the bezel PCB assembly from the main PCB and remove the five
screws that hold the front bezel cover to the printer.
3600M.044
Power
Intermec Intermec
3600
Alert
Feed/Pause
Empty/Pause
Front bezel
cover