Genicom 3600 - Manual (Page 68)

3600 Printer Maintenance Manual
c 3 9 c 3 9 frank
3-24
Note: This is a change in procedure from previous printhead alignment
instructions that directed the printhead adjustment lever to be in the neutral/center
position during alignment.
4. Install the printhead alignment tool and press the printhead assembly
down on the platen roller. Align the tool with the notches in the heat sink
and the printhead.
5. Alternately tighten the two 9/64 inch printhead yoke screws until secure.
6. Remove the printhead alignment tool.
7. Return the printhead adjustment lever to the neutral/center position.
8. Reload media (and ribbon if used).
9. Install the media cover and the power cord.
10. Switch on printer power and test for proper printhead alignment by
printing out the print quality and pitch labels.
Guide pin
(Align with the notches
on the heatsink and printhead.)
Printhead
alignment
tool
Place the cutouts
of the printhead
alignment tool onto
the shaft of the platen
roller.
Notch
Heatsink
Printhead
alignment
tool
Power
Intermec
3600
Alert
Feed/Pause
Empty/Pause
3600M.040
Printhead
lift lever