IBM RS/6000 - Manual (Page 147)

N ampx bus_intr_lvl 11 (A )
N scsi bus_intr_lvl 13 (A )
3. Select an Interrupt Level that is not currently in use.
4. If any ISA adapter is installed, check for available Bus I/O Address values by
entering the following command:
lsresource -l bus -a | grep bus_io
This command generates a list of adapters using bus I/O that looks similar to
the following:
O fda bus_io_addr x 3f - x 3f5
O fda bus_io_addr2 x 3f7
O ppa bus_io_addr x 3bc - x 3be
O sa bus_io_addr x 3f8 - x 3ff
O sa1 bus_io_addr x 2f8 - x 2ff
O sioka bus_io_addr x 6
O sioma bus_io_addr x 6
O ampx bus_io_addr x 2a - x 2a6
O sa2 bus_io_addr x 1 4 - x 1 7
O scsi bus_io_addr x f - x f ff
O scsi1 bus_io_addr x 1 - x 1 ff
5. Select a Bus I/O Address that is not currently in use.
6. If any ISA adapter is installed, check for available Bus Memory values by
entering the following command:
lsresource -l bus -a | grep bus_mem
This command generates a list of adapters using different Bus Memory
Addresses that looks similar to the following:
B ampx bus_mem_addr x e - x e1fff
B apm bus_mem_addr x e2 - x e3fff
B gga bus_mem_start x 1 - x 1ffffff
7. Select a Bus Memory that is not currently in use.
The valid Bus Memory values for use with the X.25 Interface Co-Processor ISA
Adapter start at 0x0e0000 and increment by 0x002000. For example, they are
0x0e2000, 0x0e4000, 0x0e6000, and so on. The previous example shows
ampx is using the first Bus Memory range of 0X0e000, and apm is using the
second range of 0x0e2000.
8. Install the X.25 Interface Co-Processor ISA Adapter device driver and
diagnostic by choosing:
smit isa
Install ISA Adapter Software
to install the fileset device.isa.c1x.
9. After installing the software, you might enter:
smit isa
Add an ISA Adapter
10. Select articmpx isa X.25 Coprocessor/1 Adapter from the SMIT pop-up
menu.
11. Select bus1 Available ISA Bus from the following SMIT pop-up menu.
Chapter 6. Adapter and Device Configuration on PCI-Based RS/6000 Servers 123