IBM RS/6000 - Manual (Page 57)

Figure 10. RS/6000 Model F30 Bays
Standard bays are composed of four media and six hot-swap disk bays which
accommodate the following drives:
Two of the media bays accommodate the following standard devices:
– 3.5-inch diskette drive bay that accommodates a standard 1.44 MB diskette
drive
– 5.25-inch CD-ROM drive bay that accommodates a Quad-speed 680 MB
CD-ROM drive with the convenience of loading a CD without a caddy. The
tray loading mechanism provides support for 12cm and 8cm disks.
The additional two media bays are empty on standard configuration. They
measure 5.25 inches wide by 1.6 inches high, and they can accommodate
3.25- and 5.25-inch drives, such as CD-ROM, tape drives and hard disks.
One hot-swap disk bay accommodates a standard 2.2 GB disk drive. This disk
can be upgraded to an 4.5 GB disk drive in the initial order.
The additional available five hot-swap disk bays are empty in system standard
configurations.
Slots
Ten slots are available which can accommodate the following adapters types:
Three slots for PCI adapters
Three slots for ISA adapters
Four slots that can accommodate either a PCI or an ISA adapter
Integrated SCSI-2 Adapter
Chapter 2. PCI-Based RS/6000 Server Hardware 33