IBM RS/6000 - Manual (Page 166)

7.3 Cabling the SCSI-2 Fast/Wide Differential PCI Adapter
The following tables describe the cables, terminator features, part numbers, and
lengths for the SCSI-2 F/W Differential PCI Adapter (FC 2409).
The maximum supported cable length for configurations is 25 meters
(approximately 80 feet).
7.3.1 Adapter-to-First Device Cables
This table describes the SCSI-2 Fast/Wide Differential PCI Adapter cables for
connection to the first device.
Table 29. SCSI-2 Fast/Wide Differential Adapter-to-First Device Cables
M/T F/C Part
Number Length
(meters) Cable Description
Host
System 2112 06H6037 1.0 Adapter-to-first device (where first
device has two connectors), 8-bit
narrow bus
Host
System 2114 52G0173 0.94 16-bit Y-cable
Host
System 2116 06H6036 1.0 Adapter-to-first device (where first
device has two connectors), 16-bit
wide bus
Note:
1. When cables are ordered by feature code, the appropriate terminator is included with
the order. When cables are ordered by part number, only the cable is included. For
terminator part numbers, refer to Table 31 on page 144.
2. For this adapter the same cable can be used for either single-ended or differential
attachments. The difference in Feature Code orders is the terminator type. Refer to
Table 26 on page 140.
3. The external connector on this adapter is the SCSI-3 standard, 68-pin "P" cable
connector. Many of the 18-bits SCSI devices also use this connector type, and as a
result some cables can be used as either adapter-to-first device or device-to-device
cables, depending upon what type of SCSI connectors are present on the devices.
142 Introduction to PCI-Based RS/6000 Servers