IBM RS/6000 - Manual (Page 165)

7.2.2 Device-to-Device Cables
This table describes the device-to-device cables for single-ended applications.
Table 27. Device-to-Device Cables for Single-Ended Installations
M/T F/C Part Number Length
(meters) Cable Description
SE
Bridge
Box 2840 33F4607 0.7 Device-to-Device (where
second device has two
connectors), 8-bit narrow
bus
SE
Bridge
Box 3130 31F4222 0.66 Device-to-Device (where
second device has one
connector), 8-bit narrow bus
SE
Bridge
Box 2860/9139 52G9921 0.3 Device-to-Device (where
second device has two
connectors), 16-bit wide bus
SE
Bridge
Box 2884/9160 52G4291 0.6 Device-to-Device (where
second device has two
connectors), 16-bit wide bus
SE
Bridge
Box 2883/9150 52G4233 2.5 Device-to-Device (where
second device has two
connectors), 16-bit wide bus
Note:
Most feature codes for cables are only orderable against the attachment device (7204,
7206, 7208, etc). For some cables the feature codes have been made available on the
system units. In these cases, the system feature code will be listed; otherwise the
attachment device feature codes will be used.
7.2.3 Terminators for Use with this Adapter
This table describes the terminators for single-ended installations.
Table 28. Terminators for Single-Ended Installations
M/T F/C Part
Number Connector Terminator Description
SE
External
devices part of
cable F/C 52G4260 50-pin low
density 8-bit external FPT18C
terminator
SE
External
devices part of
cable F/C 92F0432
(52G9907) 68-pin high
density 16-bit external Boulay
terminator
SE
Internal
Cabling part of
cable F/C 92F0322
(92G2566) 68-pin high
density 16-bit external bus
terminator
Chapter 7. SCSI Cabling 141