Konica Minolta BIZHUB PRO bizhubPRO920 User Manual
Page 187
Basic Job Settings
9
bizhub PRO 920
9-19
Basic Job Set
tings
Ch
ap
te
r 9
–
To specify a custom size:
Touch [Custom] to display the Custom Size Setting Screen.
Touch [X] or [Y] to highlight it, then use the control panel keypad to
enter the desired horizontal or vertical size, respectively. Entered
size should fall within 100 mm × 148 mm ~ 314 mm × 460 mm.
Touch [Lead Edge], [Rear Edge], or [Center] to specify the desired
image position.
When all settings are completed, touch [OK] to return to the Change
Bypass Tray Setting Screen.
–
To specify a wide size:
Touch [Wide Paper] to display the Wide Size Paper Setting Screen.
Touch the desired wide size to highlight it, then touch [Lead Edge],
[Rear Edge], or [Center] to specify the desired image position.
Touch [Input Size] to display the Size Input Screen.
Touch [X] to highlight it, then use the control panel keypad to enter
the desired horizontal size. Entered size should fall within the range
from the horizontal size of the standard size corresponding to the
selected wide size, to a maximum of 460 mm.