Konica Minolta BIZHUB PRO bizhubPRO920 - Manual (Page 363)

Finishing / Paper Fold 12
bizhub PRO 920 12-37
Finishin
g / Pap
e
r
F
o
ld
Ch
ap
te
r 12
To Stop Scanning/Printing
To cancel the tandem copying job:
1
Press [Stop] on the control panel of the master machine.
The scanning/printing job stops immediately, and the popup menu ap-
pears on the Basic Screen of the master machine to ask you whether
to continue or terminate the job. At this time, the tandem mode is not
yet released.
2
Touch [Stop Job] to delete all the scanned data and to release the tan-
dem mode.
However, if the data transmission has already been completed, the tan-
dem job on the tandem machine has to be cancelled separately. Touch
[Job List] on the touch panel of the tandem machine to display the Job
List Screen, then delete the tandem job.
To stop the job cancelling procedure, touch [Continue] on the popup
menu.
To cancel the job on the tandem machine only:
1
Press [Stop] on the control panel of the tandem machine.
The tandem machine stops the current operation immediately, and the
popup menu appears on the Basic Screen of the tandem machine to
ask you whether to continue or cease the operation. At this time, the
tandem mode is not yet released.
2
Touch [Continue] to go on, or [Stop Job] to delete all the data transmit-
ted from the master machine and to release the tandem mode.
The master machine will take over the remaining print quantity and
complete the job.