Konica Minolta BIZHUB PRO bizhubPRO920 - Manual (Page 383)

Advanced Information 14
bizhub PRO 920 14-7
Ad
va
nc
ed
In
fo
rm
a
tio
n
Ch
ap
te
r 14
6
Make a sample copy.
– Position originals in the ADF. Or, use Separate Scan mode to scan
all originals.
Press [Proof Copy] on the control panel or touch [Proof Copy] on
the Check Screen. A sample copy will be output.
– Press [Stop] to suspend the proof copying. In this case, the
scanned image data will not be deleted from memory.
– If any setting change is required, return to step 4, then repeat proof
copying, as required. However, you cannot change or release se-
lections that appeared dimmed after proof copying.
– If the copy result is satisfactory, touch [Close] on the Check Screen
to return to the Basic Screen, then proceed to the next step.
7
Change the print quantity, as required.
8
Position originals, then press [Start].
If proof copying has been made, the machine will simply start printing
without scanning originals.
2
Note
If the desired selection cannot be changed, press [Stop] to delete all the
data in memory, then press [Reset] to restart the job setting.