Konica Minolta BIZHUB PRO bizhubPRO920 - Manual (Page 341)

Finishing / Paper Fold 12
bizhub PRO 920 12-15
Finishin
g / Pap
e
r
F
o
ld
Ch
ap
te
r 12
– Touch [OK]. The Finishing setting menu will be restored.
? Do you want to restore the previous setting?
% Touch [Cancel].
? How does the [Off] key function?
% Touching [Off] will release the Finishing function without cancelling
newly specified information.
5
Touch [OK] on the Finishing setting menu.
The Basic Screen will be restored.
2
Note
If no other settings are required, you don’t have to touch [OK] to restore
the Basic Screen. Position originals, then press [Start] to start the printing
job.
If the Finisher FS-509 is mounted with 100-sheet-staple cartridges and
[Stop] is pressed to cease the printing job in Staple mode, the number of
printed sheets in the last sorted/grouped set determines to staple or not
to staple the unfinished set(s).
50 sheets or less: Unfinished set(s) will not be stapled upon exit.
51 sheets or more: Unfinished set(s) will be stapled upon exit.
2
Reminder
The primary (main) tray gradually goes down while printed materials out-
put. DO NOT allow any object to interfere with the operation of the tray
on the left side of the finisher, as any interference may cause damage to
the finisher.