Konica Minolta BIZHUB PRO bizhubPRO920 - Manual (Page 206)

9 Basic Job Settings
9-38 bizhub PRO 920
Basic Job Set
tings
Ch
ap
te
r 9
9.6 Separate Scan Mode
Use Separate Scan mode to scan more than 100 originals into memory then
to start a continuous printing job, or to combine images scanned from ADF
and original glass.
To set Separate Scan mode
0 Separate Scan mode is necessarily used in the following functions: Mak-
ing double-sided copies using original glass, Insert Image, Book Copy,
Program Job, Storing image in Program Image Overlay
1
Make copying selections, as desired.
2
Touch [Separate Scan] on the Basic Screen to highlight it.
The Separate Scan mode will be activated. Separate Scan may already
be highlighted depending on the selected copy conditions.
3
Position original(s), then press [Start].
– Using original glass:
Place original FACE DOWN. Start scanning from the first page.
Repeat this step for all originals.
– Using ADF:
Position originals FACE UP.
If the number of originals exceeds 100, divide them into blocks not
exceeding 100 sheets and load them from the block with the first
page.
When scanning job is started, the Basic Screen will slightly change to
provide some other information.