Konica Minolta BIZHUB PRO bizhubPRO920 - Manual (Page 354)

12 Finishing / Paper Fold
12-28 bizhub PRO 920
Finishin
g / Pap
e
r
F
o
ld
Ch
ap
te
r 12
12.10 Using Finisher Manually
The Finisher FS-509/FS-516/FS-604 with Post inserter PI-501 installed can
be operated manually, using the operation panel provided on the post insert-
er.
Place a set of paper into the lower tray. Upper tray cannot be used.
Available finishing modes according to the optional configuration are de-
scribed below.
-
Finisher FS-509/516 + Post inserter PI-501
– Staple (1 staple / 2 staples)
- Finisher FS-604 + Post inserter PI-501
– Staple (1 staple / 2 staples)
– Fold&Staple
– Letter Fold
- Finisher FS-509/516 + Post inserter PI-501 + Punch kit PK-505
– Staple (1 staple / 2 staples)
– Punch
- Finisher FS-604 + Post inserter PI-501 + Punch kit PK-505
– Staple (1 staple / 2 staples)
– Fold&Staple
– Letter Fold
– Punch
2
Reminder
The Z folding unit ZU-602 cannot be used for manual punch. To use
Punch mode manually, Punch kit PK-505 is necessary.
Start/Stop button
Fold&Staple
1 oblique staple
2 parallel staples
Letter Fold Punch