Lanier AP206 - Manual (Page 103)

Using the Operation Panel
90
5
❖ ❖ ❖ ❖ H.Parallel IF
You can select the parallel interface timing. When “SystemDefault” is select-
ed, the setting in the “System Menu” is used.
• SystemDefault
• ACK Inside
• ACK Outside
System Menu
The following are the settings you can make with the “System Menu”.
Note
❒ Italicized settings indicate default settings.
❖ ❖ ❖ ❖ 1. Paper Tray
You can select the default paper tray that is selected whenever you turn on
the printer.
• Tray 1
• Tray 2 (option)
Note
❒ If [Auto Tray Select] is selected on the printer driver, printing starts with the
tray specified here. If the specified type of paper is not set in the tray, then
the paper will be fed from the other tray.
❖ ❖ ❖ ❖ 2. I/O Buffer
You can select the size of the I/O buffer. Normally it is not necessary to
change this setting.
• 16KB
• 32KB
• 64KB
• 128KB
• 256KB
• 512KB
• 1024KB
• 2048KB
❖ ❖ ❖ ❖ 3. Energy Level
You can select the Energy Saver mode level. “Level 1” is the default setting
and saves more power consumption than ”Level 2”.
When you select “Off”, the printer will never enter the Energy Saver mode.
• Level 1
• Level 2
• Off