Media> j 1. paper tray l, Media> j 2.paper size l, Paper size> j *auto detect l – Lanier AP206 User Manual
Page 43: Custom> l jl/# width 210mm, Custom> l jl/# width 110mm
Paper and Other Media
30
3
❒ The front and side guides
should be set to the correct pa-
per size to avoid paper feed
problems.
❒ Do not mix different kinds of
paper in the tray.
❒ To avoid paper multi-feeds,
shuffle sheets before setting
them in the tray.
D
Slide the paper tray completely
into the printer.
Important
❒ Be sure to insert the paper tray
completely, or paper misfeeds
might occur.
❒ If the paper size shown on the
panel display differs from the
size of paper actually loaded,
re-adjust the position of the pa-
per guides.
Selecting paper size using the operation
panel
Use the following procedure to speci-
fy the paper size from the printer's
operation panel after loading custom
size paper into the standard paper
tray.
Note
❒ You can set the custom size paper
in the standard tray or the Paper
Cassette Type204 (option) only.
❒ After pressing a key, wait until the
display changes as described be-
fore performing the next key oper-
ation.
A
Press
{{{{Media}}}}.
The “Media” menu appears.
<Media> j
1. Paper Tray l
B
Press
{{{{U
U
U
U}}}} or {{{{T
T
T
T}}}} to display “Pa-
per Size”, and then press
{{{{#Enter}}}}.
<Media> j
2.Paper Size l
The “Paper Size” menu appears.
<Paper Size> j
*Auto Detect l
C
Press
{{{{U
U
U
U}}}} or {{{{T
T
T
T}}}} to display “Cus-
tom”, and then press
{{{{#Enter}}}}.
The following message appears.
<Custom> l
jl/# Width 210mm
D
Press
{{{{U
U
U
U}}}} or {{{{T
T
T
T}}}} to change the
third (leftmost) digit of the paper
width.
<Custom> l
jl/# Width 110mm
Power
On Line
Data In
Reset
Escape
Menu
Media
Enter
Error
ZDHS021E