Lanier AP206 - Manual (Page 51)

Troubleshooting
38
4
Open Rear Cover
Remove Misfeed
There is a paper misfeed in the
printer. Remove the misfed paper.
⇒ P.56 “When the Message
"Open Rear Cover Remove
Misfeed" Appears”
Paper Size Error There is a difference between
the paper size in the tray and
the requested paper size from
the computer. Check if the correct paper is
set
⇒ P.29 “Loading Paper”
Paper Type Error There is a difference between
the paper type in the tray and
the requested paper type from
the computer. Check if the correct paper is
set
⇒ P.29 “Loading Paper”
Remove Misfeed From Output
Tray There is a paper misfeed in the
printer. Remove the misfed paper.
⇒ P.57 “When the Message
"Remove Misfeed From Out-
put Tray" Appears”
Remove Misfeed From Paper
Tray There is a paper misfeed in the
printer. Remove the misfed paper.
⇒ P.54 “When the Message
"Remove Misfeed From Paper
Tray" Appears”
Reset Cleaner
Correctly
The fuser cleaner roller is not
installed in the printer. Install the fuser cleaner. ⇒
P.76 “Replacing the Fuser
Cleaner”
Reset Fusing Unit Correctly The fusing unit is not installed
in the printer. Contact your sales or ser-
vice representative.
Reset PCU Correctly The photoconductor unit is not
installed in the printer. Install the photoconductor
unit.
⇒ P.68 “Replacing the
Photoconductor Unit”
Reset Paper Tray Correctly The paper tray is not installed
correctly. Install the paper tray cor-
rectly.
Reset Transfer
Roller Correctly
The transfer roller is not in-
stalled correctly. Contact your sales or ser-
vice representative.
Reset xxx Toner Correctly The indicated toner cartridge is
not installed in the printer. Install the indicated toner
cartridge.
⇒ P.66 “Replacing
the Toner Cartridge”
Warming Up The printer is warming up or
processing internally. Wait until the printer re-
turns to the ready condition
or finishes processing inter-
nally.
Waste T Full The waste toner bottle is full. Replace the waste toner
bottle.
⇒ P.75 “Replacing the
Waste Toner Bottle”
Waste Toner is Full The waste toner bottle is full. Replace the waste toner
bottle.
⇒ P.75 “Replacing the
Waste Toner Bottle”
Message Description Comments