Lanier AP206 - Manual (Page 67)

Troubleshooting
54
4
Removing Misfed Paper
When a paper misfeed occurs, an er-
ror message appears on the panel dis-
play. The procedure you should
follow to remove misfed paper de-
pends on the location of the misfeed
indicated on the panel display.
R CAUTION:
Important
❒ Toner printed on misfed paper is
not fused and can make your
hands or clothing dirty. Take care
to avoid contact with the toner as
you remove misfed paper.
❒ Check the following points if pa-
per continues to misfeed.
• Confirm that paper is properly
loaded in the paper tray.
• Confirm that the number of
sheets does not exceed the max-
imum amount for the tray.
• Confirm that the paper in the
tray matches the size for which
the tray is set up.
• Confirm that misfed paper is
still not inside the printer when
you resume printing.
❒ If a paper misfeed still occurs, con-
tact your sales or service represen-
tative.
❒ Do not touch the photoconductor
unit when removing misfed paper.
If you do, the photoconductor unit
might be damaged.
When the Message "Remove
Misfeed From Paper Tray"
Appears
A
Pull out the paper tray.
Note
❒ If your printer has an optional
paper feed unit installed, check
all paper trays for misfeeds.
B
Carefully pull the misfed paper.
Make sure that you do not leave
any misfed paper in the printer.
• When accessing the inside of
the machine, do not touch any
sections other than those
specified in this manual. If you
do, it might result in receiving
a burn or injury.
• The paper tray does not have
a stopper. When pulling it out,
be careful not to pull it strong-
ly. If you do, the tray might fall
and cause a personal injury.
ZDGY010J
ZDGY090J